This product consist of two boards. Base board is an ESP32-S3-WROOM-1-N8R8 module with Bluetooth, Wifi and a CAN transceiver. On board is a RGB LED, boot and reset button. Programming is done via USB C. Top board has two potentiometer, two push buttons and four LEDs for NMEA2000 device simulation.
Features
- ESP32-S3 series of SoCs embedded, Xtensa dual-core 32-bit LX7 microprocessor (with single precision FPU), up to 240 MHz
- 8MB Quad SPI flash
- 8MB PSRAM
- Bluetooth LE, Bluetooth 5 and Bluetooth mesh
- Wifi 802.11b/g/n
- On-board PCB antenna
- Programming via USB-C connector
- Boot and Reset push button
- CAN transceiver
- I2C connector for sensors
- Supply voltage : 7v to 24v SMPS module with reverse polarity protection
- RGB LED
- Top board:
- 2x potentiometer
- 2x push button
- 4x LED
Documents
- Base board schematic. Top board schematic
- Arduino example sketch
Example sketch simulate temperature on PGN 130316, adjustable via pot P1. Humidity on PGN 130313, adjustable via pot P2.
Unconditional Satisfaction Guarantee
