50% OFF! Hot items selling fast—Grab them before they're gone!
Unconditional Satisfaction GuaranteeNo Shipping Fees Above 302 Months to Decide. Returns Simplified.A two-port screw terminal designed to work in a building brick or conductive sewing based environment. Screw in standard components to connect them to the Crazy Circuits system.
Like all of our Brown Dog Crazy Circuits components, this terminal is soldered to a small circuit board with large building brick-sized holes in it. The overall PCB size is the same as a 2×2 building brick component. The part is designed to connect to other components in a brick-based environment using conductive tape.
This partcan also be used with Conductive Thread for use in Soft Circuits. Just sew through the large copper plated holes to make your circuit. For quick testingyou can also use alligator clips to connect this to other components.
Typically this part is used to connect a 2xAA or 2xAAA battery holder for use in the Crazy Circuits system. However any 2-pin or 2-wire component can be plugged in, such as LEDs, motors or speakers.
View other ‘Chips’ in the range or check out our wearables section for more wearable/cosplay items!
